York Fitness inspiration 100 Owner's Manual download pdf (Page 6)

Getting Started

Place all parts from the box in a cleared area and position

them on the oor in front of you. Remove all packing

materials from your area and place them back into the box.

Do not dispose of the packing materials until assembly

is completed. Read each step carefully before beginning.

If you are missing a part, please contact our technical

support.

After unpacking the unit, open the hardware bag and make

sure that you have all the following items. Some hardware

may be already attached to the part.

Hardware Identiﬁcation Chart

This chart is provided to help identify the hardware used

in the assembly process. Place the washers, the end of

the bolts, or screws on the circles to check for the correct

diameter. Use the small scale to check the length of the

bolts and screws.

NOTE: The length of all bolts and screws except those

with at heads is

measured from below

the head to the end of

the bolt or screw. Flat

head bolts and screws

are measured from

the top of the head to

the end of the bolt or

screw.

Part No. 15 x 4

CARRIAGE (M10 X 88MM)

Part No. 29 x 4

FLAT WASHER (ID10.5 X OD23 X T1.5MM))

Part No. 27 x 1

FLAT WASHER (ID8.5 X OD13 X T1.5MM)

Part No. 24 x 4

NYLOC NUT (M10)

Part No. 21 x 1

ROUND ALLEN HEAD BOLT (M8 X 15MM)

Part No. 5 x 1

STOP BRACKET (56 X 20 X T2MM)

Part No. 25 x 1

NYLOC NUT (M8)

Part No. 43 x 4

ROUND PLASTIC BOLT CAP (M10 X OD30MM)

Part No. 17 x 2

HEX HEAD BOLT (M8 X 16MM)

Part No. 22 x 2

ROUND PHILLIPS HEAD MACHINE SCREW (M5 X 6MM)

Part No. 28 x 2

FLAT WASHER (ID8.5 X OD28 X T2MM)

Part No. 30 x 2

PLASTIC SPACER (ID12.8 X OD19 X 38MM)

Part No. 51 x 2

SCREWDRIVER AND ALLEN KEY

Part No. 52 x 1

MULTI SPANNER (13, 17MM)

assembly instruction

1 2 3 4 5 6 7 8 9 10 11 ... 15 16

Comments to this Manuals

No comments

York Fitness inspiration 100 Owner's Manual Page 6

Comments to this Manuals

Related products and manuals for Spin bikes York Fitness inspiration 100