York Fitness Treadmill User Manual download pdf (Page 4)

CENTERING THE RUNNING BELT

The running belt has been properly adjusted at the

factory before it was shipped. At times the belt can

move off-center during shipment. Before operating

the treadmill, make sure the belt is centered and

remains centered to maintain smooth operation.

CAUTION: Do not run belt faster than 1 mph while

centering. Keep fingers, hair and clothing away from

belt at all times.

If the running belt is too far to the right side: With the

treadmill running at 1 mph, turn the right adjustment

bolt clockwise 1/4 TURN at a time (using the supplied

Allen wrench). Check the belt alignment. Allow belt to

run a full cycle to gauge if more adjustment is needed.

Repeat if necessary, until the belt remains centered

during use.

If the running belt is too far to the left side: With the

treadmill running at 1 mph, turn the left adjustment

bolt clockwise 1/4 TURN at a time (using the supplied

Allen wrench). Check the belt alignment. Allow belt to

run a full cycle to gauge if more adjustment is needed.

Repeat if necessary, until the belt remains centered

during use.

Belt is too far to the right side

Belt is too far to the left side

TENSIONING THE RUNNING BLET

The running belt has been properly adjusted at the

factory before it was shipped. At times the belt can

move off-center during shipment.

CAUTION: Running belt should NOT be moving

during tensioning. Over-tightening the running belt

can cause excessive wear on the treadmill as well as

its components. Never overtighten the belt.

If you can feel a slipping sensation when running on the

treadmill, the running belt must be tightened. In most

cases, the belt has stretched from use, causing the

belt to slip. This is a normal and common adjustment.

To eliminate this slipping, TURN THE TREADMILL

OFF and tension BOTH THE REAR ROLLER BOLTS

(left and right adjustment bolt) using the supplied Allen

wrench, turning them 1/4 TURN to the right as shown.

Turn the treadmill on and check for slipping. Repeat

if necessary, but NEVER TURN the roller bolts more

than 1/4 turn at a time. Belt is properly tensioned when

the slipping sensation is gone.

TURN POWER ON

Make sure that your treadmill is properly connected to a power outlet. The on/off switch is located next to the

power cord. Flip this switch to the ‘on’ position, so that the switch is lit.

You will hear a beep and the console will light up.

LEVELLING

The treadmill should be leveled for optimum use. Once you have placed the treadmill where you intend to use it,

raise or lower the adjustable levellers located on the treadmill base frame. Once you have levelled the treadmill,

lock the levellers in lace by tightening the pad against the frame. To assure the treadmill is level, a carpenter’s

level is recommended.

1 2 3 4 5 6 7 8 9 ... 16 17

Comments to this Manuals

No comments

York Fitness Treadmill User Manual Page 4

Comments to this Manuals

Related products and manuals for Treadmills York Fitness Treadmill